Experimental Investigation on Corrosive Wear of Hand Laid Composite Laminate for Direction Control Rod of Boat

Asian Resonance(E: ISSN No. 2349-9443 RNI No.UPENG/2012/42622 VOL.-8, ISSUE-1,January (Part-1) 2019)

Abstract


 Sendil Kumar R 

Assistant Professor, Dept. of Mechanical, Dhanalakshmi College of Engineering, Chennai, Tamil Nadu, India


Pradeep Kumar A R 

Professor, Dept. of Mechanical, Dhanalakshmi College of Engineering, Chennai, Tamil Nadu, India


Elumalai R 

Assistant Professor, Dept. of Mechanical, Dhanalakshmi College of Engineering, Chennai, Tamil Nadu, India

 The experimental study used a hand laying technique for fabricating a composite material, which has been tested further for replacing the material used for direction control rod of a boat. The aim of the experiment is to minimize the corrosion by using fibre materials. The materials used for preparing the composite material are glass, nylon and jute based on their properties along with epoxy (LY556). The hardener used was HY651matrix. The hand laying technique has been used to prepare the composite The prepare composite material were laminated over the galvanized iron rod, which was similar in shape of a direction control rod. The salt spray test has been conducted for 120 hours and immersion test was conducted for a period of 48 hours. The sodium chloride solution has been used for both the tests. The results obtained were compared with fibre laminates.

for full paper please visit below link :

http://www.socialresearchfoundation.com/upoadreserchpapers/1/357/2007161106511st%20sendil%20r.%2012091.pdf


Comments

Popular posts from this blog

Management of Cytotoxic Drugs And Related Wastes Disposal

गृह प्रबन्ध में बचत की आव‛यकता और महत्व The Need and Importance of Saving In Home Management

Utilization of Information Sources By Farmers